3D-printer in the form factor of the handle




3D-printer in the form factor of the handle

Not so long ago, WobbleWorks made a splash on Kickstarter, raising over $ 2 million for the project 3Doodler – 3D-printer format formed in the handle and having a drive rail. WobbleWorks tried to repeat the success of the company Swiss 3D Print, which announced almost similar product SwissPen. As in the case of 3Doodler, by modeling SwissPen manually. The gadget allows you to print three-dimensional and two-dimensional conditionally “sketches”. Device width does not exceed 3.6 cm, while the weight is 198 grams. As print media used and ABS polymers PLA thickness 1.75 mm. Goes to heating, on average, up to the minute.

According to the Swiss 3D Print, heated filler is not harmful to the skin and does not leave serious burns, but nevertheless, children under 12 should refrain from using SwissPen, or at least enlist the help of adults. The cost of new items is approximately $ 103. The kit includes a test set of 220 fillers (25 cm in length) 11 colors. The product will be available in October.



In: Technology & Gadgets Asked By: [15446 Red Star Level]

Answer this Question

You must be Logged In to post an Answer.

Not a member yet? Sign Up Now »